Force CID stopped working with new server

Found something wrong ?
ronf
Posts: 6
Joined: Mon Jun 18, 2012 5:24 pm

Re: Force CID stopped working with new server

Post by ronf » Fri Jul 06, 2012 3:34 am

Solved! Thank you Aaron. Changing one of the providers mattered, with or without leaving two in the call path (became obvious when thinking about the shorter paths). The two I used do require different routing instructions in FreePBX and that change was necessary. Still not sure why one of the 2 incoming route setups started working again. It seems now to be setup the same as before when it temporarily failed. Perhaps I may have corrected something without realizing it (or perhaps you changed something?). In any case I very much appreciate your guidance as it led me to the solution.

Aaron
Site Admin
Posts: 4652
Joined: Thu Jul 12, 2007 12:13 am

Re: Force CID stopped working with new server

Post by Aaron » Fri Jul 06, 2012 7:56 am

Glad to hear it's working. THere haven't been any changes made to the SIPSorcery service since the server migration.

Post Reply